Mulch Dos and Don’ts
Mulch Dos and Don’ts
This is not a good way to mulch your trees. Volcano mulching may cause:
- Decay and fungus in the base of the trunk when too much moisture is held in by the mulch
- Soil that is too dry for the roots to spread and create a stable base due to an impenetrable layer of mulch keeping water from filtering down
- Lack of air in the soil, resulting in suffocating the roots
- Insect and rodent damage
The effects of volcano mulching may not show up right away – in fact, unless you’re looking, it can take years for the effects to show. If you were to clear mulch away from the base of a tree that has been over-mulched, you might see that the bark has rotted off and the inside of the tree is exposed. Perhaps the leaves on your trees are smaller than normal, or yellow. Or, in extreme cases, trees with unstable root systems due to volcano mulching could fall over during a storm.
Properly-applied mulch will look somewhat like a flattened donut, with plenty of space in the middle for the flare and root ball to breathe. Here are some tips for how to mulch to promote tree health:
- Immediately after planting a tree, take care to mulch the planting area with 2 to 4 inches of mulch
- If you are applying mulch to an existing tree, carefully create a shallow edge within the drip line of the canopy, taking care to avoid damaging the roots, before you lay mulch down
- Do not mulch up to or against the trunk; start the mulch 6 inches away from the tree trunk. You should be able to see the “flare” at the base of the trunk where the first roots start to branch out
Need Mulch?, or have questions about your landscape? Contact Johnson Ops Tree Care at 608 526-6297. One of our ISA Certified Arborists will meet with you and answer any questions you may have regarding your landscape.