Trees, Saws and Ladders Don’t Mix
Trees, Saws, and Ladders Don’t Mix
In February 2016, a homeowner was seriously injured after falling from a ladder while trimming branches from a tree in Frederick, Oklahoma. The man was using a chainsaw to trim broken limbs from the trees around his home. One of the limbs he severed fell into his ladder, knocking it over and causing the man to fall 12 feet to the ground. The man was discovered by a neighbor, lying face down in the yard beneath the tree. The badly bent ladder and chainsaw were strewn on the ground nearby. He was taken by helicopter to OU Medical Center due to the nature of his injuries. Trees, Saws, and Ladders Don’t Mix!
This story is, unfortunately, not an isolated incident and staff arborist for the Tree Care Industry Association. There are many stories in the news media each year depicting the sad details of homeowners getting severely injured or killed by attempting to manage large tree limbs on their own. Tree work, while appearing straightforward and simple, is extremely complicated and technical. There is so much to understand about removing live or hanging tree branches, and it is not at all like cutting up firewood on the ground with a chainsaw.
Qualified tree professionals are trained to look for and take special precautions against:
- Trees or branches with decay, cracks, or unbalanced weight
- Working near overhead electrical wires and other conductors
- Preventing falls from trees they are working in
- Removing portions of or entire trees without causing bodily harm or property damage
Do-it-yourself homeowners have been hurt trying to cut their own trees in the following manners:
Oops! If your ladder is too short to reach the branch, do not make the mistake of setting it on something such as an overturned garbage can to get the reach you need. Get a sturdy ladder that will reach at least 5 feet beyond the branch you lean it on. When a large branch is cut from a tree, the loss of weight will cause the rest of the limb to suddenly lurch up. Many unaware homeowners have been severely injured, some fatally, when the ladder they are standing on falls out from under the branch they are cutting. The biggest danger is taking too big or too unwieldy of a piece at one time. Cut the limb in small pieces.
Are you going to borrow your brother-in-law’s chainsaw? When was the last time that tool was properly sharpened or maintained? A dull chain forces you to use too much pressure, causing you to lose control. This can lead to many problems, most of them leading to the hospital for emergency treatment of deep lacerations to your body. Use properly maintained equipment and the right size saw for the job.
Lack of knowledge about tree physics and biology
It can’t be done with just one cut. This is where those lacking experience in cutting live limbs from trees get hurt almost every time. Trees are mechanically complex organisms that need to be cut in a certain way to remove pieces of them safely. Cutting off a large section of the limb to save time will usually cause the branch to fall before the cut is finished. The cut end will often tear into the branch all the way back to the trunk. This action can cause damage to the tree (and to you) as it swings out of control, usually onto the ladder you are standing on – or the person holding the ladder. Therefore, it is always recommended to remove a large limb in sections.
If you are at all uncertain about what could happen by attempting your own tree work, contact a qualified tree care professional.
Find a professional
A professional arborist like Johnson Ops tree Care we can determine the best way to accomplish the task at hand and has the experience and proper equipment to do the job. And in doing so, they just may prevent an injury or even save a life.
Call us for an appointment at 608 526-6297